Is there yet a recommended frequency setting for the Blue belt?
I haven't seen anything since a topic in 2017
Search found 18 matches
- Wed May 26, 2021 20:13
- Forum: Engine and Gearbox
- Topic: Gates Racing Blue belt tension
- Replies: 2
- Views: 1029
- Mon May 17, 2021 10:38
- Forum: Engine and Gearbox
- Topic: Oil Change Advice
- Replies: 30
- Views: 8848
Re: Oil Change Advice
Some replies to the above (for which thank you all) It's several years since the oil was changed (too many I know) - to Mobil 1. Annual mileage is about 500 mostly short journeys including a once a month run round the adjacent main roads and a bit of motorway. No trackdays, just Sunday runs Tomorrow...
- Wed Apr 14, 2021 13:19
- Forum: Engine and Gearbox
- Topic: Oil Change Advice
- Replies: 30
- Views: 8848
Oil Change Advice
I've just been advised to change my oils as follows. Change to cheapest 20/50 and run for 100 miles. Then change to good oil, filter etc This surprised me and I wondered if anyone had a strong opinion for or against. He said synthetic oils on low mileage coat things and the budget oil allows cleanin...
- Fri Feb 19, 2021 12:35
- Forum: Engine and Gearbox
- Topic: Cam Carrier leak.
- Replies: 18
- Views: 5809
Re: Cam Carrier leak.
Have you encountered Brian Swankie in Anstruther?
- Sat Aug 24, 2019 11:15
- Forum: Bodywork, Fitments, Interior and Trim
- Topic: Replacing rear lower seatbelt mounts
- Replies: 7
- Views: 2187
Re: Replacing rear lower seatbelt mounts
Job now done. I didn't do it myself but the feedback was - not to hard to get the old ones out, the N/S was easy to fit, the O/S was a pig as the alignment of bolt holes was poor. You collective advice was appreciated by the fitter and hopefully this topic will help someone else in the future. Thank...
- Tue Aug 20, 2019 09:04
- Forum: Bodywork, Fitments, Interior and Trim
- Topic: Replacing rear lower seatbelt mounts
- Replies: 7
- Views: 2187
Re: Replacing rear lower seatbelt mounts
Thanks Hawaiis0,
They look good - is painting necessary?
Bill
They look good - is painting necessary?
Bill
- Mon Aug 19, 2019 23:12
- Forum: Bodywork, Fitments, Interior and Trim
- Topic: Replacing rear lower seatbelt mounts
- Replies: 7
- Views: 2187
Replacing rear lower seatbelt mounts
I've got to fit the new ones I got from SJ - if you have replaced these, can you offer any hints which might help me.
Thanks,
Bill
Thanks,
Bill
- Thu Nov 01, 2018 14:03
- Forum: Bodywork, Fitments, Interior and Trim
- Topic: Odometer failed - any tips
- Replies: 6
- Views: 1894
Re: Odometer failed - any tips
Job done - exactly as instructed above - thanks Angus. For the next reader - have a 20mm socket handy to loosen the nut holding the speedo in. Repaired by John at JDO. While easing/pressing/heaving the panel back in a spacer fell to the floor. Ali, about 1cm dia x .5cm thick. I don't know where it c...
- Sat Jul 28, 2018 14:40
- Forum: Bodywork, Fitments, Interior and Trim
- Topic: Odometer failed - any tips
- Replies: 6
- Views: 1894
Re: Odometer failed - any tips
Thanks guys. I think I'll use a repairer. The only one I can find is at http://www.jdo1.com/speedos.html in Keighley, Yorks and is on holiday till mid August.
I'll report the results later.
I'll report the results later.
- Tue Jul 24, 2018 18:27
- Forum: Bodywork, Fitments, Interior and Trim
- Topic: Odometer failed - any tips
- Replies: 6
- Views: 1894
Odometer failed - any tips
My car is 91 with VDO speedo in wooden panel with 4 phillips screws.
I expect to have to remove the speedo. Maybe replace a gear wheel or have it repaired.
My question is how to get the speedo out? - wheel on or off; undo the screws; atime saving tips?
Thanks,
Bill
I expect to have to remove the speedo. Maybe replace a gear wheel or have it repaired.
My question is how to get the speedo out? - wheel on or off; undo the screws; atime saving tips?
Thanks,
Bill
- Tue Sep 05, 2017 12:51
- Forum: Electrics and Electronics
- Topic: Window lift switch
- Replies: 4
- Views: 1654
Re: Window lift switch
Thanks, everyone. I bought the one on e-bay - ouch!
Brian, I'll give you a ring and pop along to visit in a week or so.
Bill
Brian, I'll give you a ring and pop along to visit in a week or so.
Bill
- Thu Aug 31, 2017 15:16
- Forum: Electrics and Electronics
- Topic: Window lift switch
- Replies: 4
- Views: 1654
Window lift switch
Can anyone supply or point me to a 6 contact switch for my '90 Excel SE?
Thanks,
Bill
Thanks,
Bill
- Tue Aug 18, 2015 15:33
- Forum: General
- Topic: PAS leaking pipe - how to replace?
- Replies: 8
- Views: 2402
Re: PAS leaking pipe - how to replace?
Thanks - it just ended . I must find out how to watch for items on e-bay
Bill
Bill
- Fri Aug 14, 2015 13:24
- Forum: General
- Topic: PAS leaking pipe - how to replace?
- Replies: 8
- Views: 2402
Re: PAS leaking pipe - how to replace?
To close this off. With pipes and a rack from Brian I'm back on the road. BTW the pipes for a late Excel with the Saginaw pump are not the same as for the older models and are not readily available - I had to get some cutting and splicing done by local hydraulics company. Anyone got a budget Saginaw...
- Thu Jun 11, 2015 16:01
- Forum: General
- Topic: PAS leaking pipe - how to replace?
- Replies: 8
- Views: 2402
Re: PAS leaking pipe - how to replace?
Thanks Brian, and apologies for not getting back to you sooner. I'll contact you off site.
Bill
Bill