The Lotus Grand Tourers

I have had a small batch of Stainless Steel rear seat belt brackets fabricated. Profits will go to club funds. Havent picked them up yet so will keep informed. Will be around £25. Hope to have them on the NEC stand next month.

Excellent! A lot of these have corroded to dust.

Pete

Pete Boole wrote: ↑

Sun Feb 18, 2024 11:13

Excellent! A lot of these have corroded to dust.

Pete

Just the bottom bracket Stu, or top as well?

Just looked closer at the picture - Top bracket . Put me down for a pair.
Tony

I’m sure I’ll need a set at some time, so put me down for a set.
Not actually checked any of mine, so might need some sooner that sometime

This is just the external inner rear wheel arch bracket. The internal bracket will be like new still.



They are listed on SJs in mild steel still, at £30 each. But you'll be paying less for Stainless and supporting our club.

Following is the first dibs list pending quality control approval. 20 will be available. 10 left and 10 right.


Stu (pair)
Tony (pair)
Alan (pair)

I have replaced the lower rear seat belt montings. This one


So where is this other one to be found? I thought I had rusty seat belt mounts covered

Tanz wrote: ↑

Tue Feb 20, 2024 18:24

So where is this other one to be found? I thought I had rusty seat belt mounts covered

Place head under wheel arch and look up and forwardish.
It’s the one that the bracket the rear seatbelt reel mounts to then bolts through to this bracket under the “parcel” shelf.

A question for Stu - the part number for these appear to have changed at VIN 89 D 2457. Which version is this, and are they backwards/forewords compatible?

Alan_M wrote: ↑

Tue Feb 20, 2024 22:06

A question for Stu - the part number for these appear to have changed at VIN 89 D 2457. Which version is this, and are they backwards/forewords compatible?

These are B's and according to the PIG :

<revision letter> indicates which version of the part was used. Later revisions should be OK to replace earlier, but not vice-versa

However, being reproductions may have nuances.

Thanks Alan for the reply.
Stu - please pt me down for a pair and thanks for doing this.

CORRECTION

They are listed on SJs in CORRECTION Stainless Steel, at £35 each. But you'll be paying less and supporting our club.

Following is the first dibs list pending quality control approval. 20 will be available. 10 left and 10 right.


Stu (pair)
Tony (pair)
Alan (pair)
Tanz (pair)

Have 20 brackets now. 10 left/right. Deposited with Pete so should get to NEC show. Quality control seemed please with them. 4 or 5 pairs allocated.

Hi Stu - I have sent you a PM regarding payment. Hope the PM is working

Stu.
I've sent you an email on same.
Tony

Replies sent to both of you. Phil yours has landed.