water pump repair kit
Posted: Fri Oct 01, 2021 11:28
My excel 1991 has done 90 k thinking i may look into servicing the water pump anyone fitted a repair kit in there. got any pointers i have a press andy
I'd say if there are no signs of leak then leave it, and wait for it to leak. They can be damaged by errors during refurb.
I've purchased one that somebody had refurbished, and it leaked when it arrived (not a problem as I purchased it for its casting thinking I may need to re-do).
That said, if you do go ahead. Heat the casting before pressing old out and new in, you don't want to drag any of the ali as the bearing moves against it. Also, bearing in the freezer before putting it in can help.
Make sure that the surface the seal is to go against (deep in the casting) is free of any corrosion / damage.
Don't press the impellor on too far, it's not great to have to try and remove, so trying to back it off a few thou I'd imagine is bad.
Make sure you measure and note down the pulley placement relative to the casting (not to the spindle end), and put it back to the same place. Location varies depending on engine arrangement, and spindle may be different length on the new bearing.