steel wheel

[carlos]

Hi, anyone happen to know if there is a steel wheel off something that would bolt directly to my 89 excel se as i need to take mine off at some point to have them straightened a little as three have a run out on inner edge.

[amarshall]

Something from Toyota around 1982 will probably fit.

[Esprit2]

Wheels with 4 x 4-1/2" (4 x 114.3 mm) Bolt Circle

Buick Special '61-'63
Chevrolet
- Corvair all 4-bolt
- Chevy II all 4-bolt
- Sprint '85-'87
- Nova ('61-'70)
................................................ Rim ...... Bolt
Datsun/Nissan - most models to '89 .... Size ...... Circle ...... ET ... Center Bore
- 240Z ....................................... 14 x 6” ... 4 x 4.5” ... +2 ... __ mm

Dodge Colt '79-'88

Ford
- Mustang all '65-'68 4-bolt
- Falcon, Maverick, Granada all 4-bolt

Honda (Acura) Legend '86-'89
...................................................... Rim ........ Bolt
Lotus ............................................... Size ....... Circle ...... ET .... Center Bore
- Elite, Eclat & Excel with alloys, ’74 -’81 ... 14 x 7” ... 4 x 4.5” ... +18 ... 70 mm
- Excel, Excel SE/ SA ............... '82 -'92 ................. 4 x 4.5"

Mazda
- 626
- RX7 '83-'87 ????

MGA/ MGB/ MGC
Oldsmobile F-85, '61-'63
Plymouth - Arrow, Sapporo '79-'88
.................... Bolt
Rover ............ Circle ...... ET ... Center Bore
- 600 ............. 4 x 4.5” ... 35 ... 64 mm
- 800 ............. 4 x 4.5” ... 35 ... 64 mm
- Maestro Van ... 4 x 4.5” ... 35 ... 64 mm

SAAB 900 to '87
Toyota most, excluding MR2 and Pick-Up to '89
Triumph TR1 thru TR6

[paulsx]

Its a common pattern for jap cars so go for and early Nissan primera or s13 200sx.

RX7/8 Wheels are same pcd but have very low offset which might be a problem

[STELL]

First generation Volvo s/V 40 fits, but you'll need a 25 mm adaptor for the offset