Seat Retrim

dpr59 · Post by **dpr59** » Sun Feb 04, 2007 09:54

Found a local place that will re-leather my drivers seat.

Thanks to a post on a classiccar forum.

It's even in Hartlepool, about 2.5 miles from the house

Now, whats the best route to getting the seat out of the car?

terry · Post by **terry** » Mon Feb 05, 2007 13:39

The best route is to onbolt the whole frame from under the car. If you are very lucky(as I was on one seat) the bolts are welded into the frame. This means that all you do is reach under the car with socket ext and rachet, and undo. If they are ordinary bolts, there's a bit of a problem, because most sockets and spanners won't get round the bolt head. A second person is invariably needed to hold the bolt into the runner to stop it turning, or get a screw driver and push it in to the side of the bolt to stop it turning.

Once off, push adjuster to unbolt chair from runners.

If you can, get the bolts welded, before they go back, or (as I did), replace with hex headed allen bolts.

Terry

mds666 · Post by **mds666** » Mon Feb 05, 2007 20:15

make sure you replace them with high tention bolts, otherwise if you have a smack you and the seat mite be floating around the car...

dpr59 · Post by **dpr59** » Mon Feb 05, 2007 21:54

Jerry wrote:Dave

Can you let me know the name of this place and any info you have on say cost etc?

Hi Jerry,

The Re-Upholstery Centre
237, York Rd, Hartlepool, Cleveland TS26 9AD
Tel: 01429 420200

A chap in Hartlepool had the seats for his Mini done for £200 each in new leather.

Haven't got a price on mine yet.

I'd not thought of a general re-upholsterers, but h=they are just seats afterall.

Must be a place near you, try www.yell.com

amarshall · Post by **amarshall** » Fri Jun 15, 2007 10:23

Has anyone tried this firm yet ?