The Lotus Grand Tourers

Hi All
Any ideas how to fix the cruise control on a Excel SA 1987 ?
The switches light up ,but the cruise will not set the speed at any speed over 30mph.
Any good ideas were the wiring goes too the autogearbox or
Kind regards
Roger

there are multiple cables to the control on the nearside wing and lots of electric wires

Mine was not working and Lotusbits sorted it out for me

texas2201 wrote:there are multiple cables to the control on the nearside wing and lots of electric wires

Mine was not working and Lotusbits sorted it out for me

Hi
Many thanks for the info.
Are Lotusbits in the southwest of the UK
Kind rgeards
Roger
Hull
East Yorkshire

hi roger, lotusbits are based in warwickshire near southam give them a call they will sort you out. cheers gerald.

http://www.lotusbits.com/ very helpful and friendly - currently got my SA for a new steering colum and UJ, cam belt and service

gerald wrote:hi roger, lotusbits are based in warwickshire near southam give them a call they will sort you out. cheers gerald.

Hi Gerald
Many thanks ,i have searched for them but can not find their website
I will keep looking ,i will have to make a special trip it is about 300 miles around trim.
I will have to see if anyone up here in Yorkshire can fix it.
Many thanks
Roger

see above

texas2201 wrote:http://www.lotusbits.com/ very helpful and friendly - currently got my SA for a new steering colum and UJ, cam belt and service

Hi
Many thanks for the link.
Cheers
Roger

No Problem Roger welcome onboard by the way

Hi Roger
Some years ago Chris Foulds in Honley, Huddersfield did an excellent job rebuilding my engine after a shredded cambelt, and has always been very helpful with any advice I've asked for. His website is:
http://www.fouldsmotors.co.uk Tel: 01484 666 552

Good Luck!

Yes Chris Foulds is yer man up North.

Shouldn't that be Up Norf or even Nawf,Peter?

Although a bonus of going to see Mike is he might take you out in his rally car .......I have just come back from Lotusbits had my universal jont on the steering column and track rod ends replaced... And that was 500mile round trip

Delsexcel wrote:Hi Roger
Some years ago Chris Foulds in Honley, Huddersfield did an excellent job rebuilding my engine after a shredded cambelt, and has always been very helpful with any advice I've asked for. His website is:
http://www.fouldsmotors.co.uk Tel: 01484 666 552

Good Luck!

Hi Derek,
Many thanks for the info ,Huddersfield is a lot closer to me.
Thanks for that
Regards
Roger
Hull
East Yorkshire

Lotus-e-Clan wrote:Yes Chris Foulds is yer man up North.

Hi Peter,
Many thanks for that
Cheers
Roger
Hull
East Yorkshire